What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
16.06.2025 03:11

I post the exact comment here.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This device then solves the entire problem.
How can you maintain self-control?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Now when you have a certain ac resistance, then a current flows in a loop.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
[old diagram got deleted by accident]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
a photo is worth a thousand words.
One
Which race of women are the hottest?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Because the load is inductive, the current lags the voltage.(by a bit).
Do all armies have the same rank structure?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This one hit behind the barn.
eight
Why would an older small breed dog become obsessive about hygiene?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
It also is a device that limits the change in current flow.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
There are three different concepts here that are getting confused.
the problem then depends on "how fast does the fuse operate?".
Upvotes:
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
He then asserts :
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Why am I so afraid that gun owners have set traps to kill me outside my house or my car?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
so, what happens?
I dreamt my mother had died and I cried so much in my dream. What does it mean?
A circuit breaker is similar, but is resettable.
In schematic diagrams this is the symbol for a fuse:
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Why do some guys treat girls so badly?
The third is lightning and “how it gets conducted into a home.”
First Sentence:
but I think this circuit , shows a few more pieces.
Why would my nipples hurt when I touch them?
Barnstars:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Do leftists understand why young men are becoming more right-wing?
He then describes Rainy Season and Lightning.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Why do British people always write "xxx" after their names?
He then describes the function of a fuse.
This is where the MOV conducts again, and dissipated the energy.
The MOV will conduct when the voltage exceeds 50% of line voltage.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
It seems Mohan does not understand the difference between a comment and an Answer.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Here is a simplified AC power diagram.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
There are two important concepts here.
For this case there are devices called Metal oxide varistors (MOV).
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
(Dc diagram shown, AC is similar).
These devices are installed between the “hot” and “neutral” and protective ground.
The bolt then partially travels down the line to your home.
2024–10–16 [ OO OLAOYE OYEBODE ]
nine
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–10[John johnson John Johnson ]
but this device (an Inductor) … impedes the rapid changes in the current.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
These are simplified answers to the original question, and does not change anything I wrote above.
An AC voltage/ current source, and an ac inductive load.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
So, the voltage could go up to 500 volts, and the fuse will not open up.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is 'the assistant's answer'
[image of Common-mode choke]
At least they know the answer if they wanted it.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
But it can get overloaded, and no longer works.
What is lightning?
The other is “what does a “fuse” do?”
what exactly is a ‘surge’ protector?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
One is “what exactly is in a ‘surge protector’ ? ”
A fuse is a non-resetable over current circuit protector.
Edit 2024–10.
What does a fuse do?